Honda Cars 2007-2008

Hydraulic System

Print

Bleeding



  1. Make sure the DOT 3 brake fluid level in the clutch reservoir is at the MAX (upper) level line. Attach one end of a clear tube to the bleeder screw, and put the other end to the container. Loosen the bleeder screw to allow air to escape from the system.
  2.  
  3. Make sure there is an adequate supply of fluid in the reservoir, then slowly push the clutch pedal all the way down. Before releasing the pedal, have an assistant temporarily tighten the bleeder screw. Loosen the bleeder screw, and push the clutch pedal down again. Repeat this step until no more bubbles appear at the clear tube.
    WARNING
    Make sure the fluid level on the reservoir does not go below MIN.

  4.  
  5. Tighten the bleeder screw securely.
  6.  
  7. Refill the brake fluid in the reservoir to the MAX (upper) level line.
  8.  

 
label.common.footer.alt.autozoneLogo