Honda Cars 2007-2008

Removal & Installation

Print

Specific to:

Honda Civic 2007-2008

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the glove box mounting bolts.
  4.  
  5. While holding the glove box, release the glove box stops on each side from the dashboard by pushing them in, and then remove the glove box.
  6.  
  7. Remove the wire harness clip, the self-tapping screws, and the passenger's heater duct.
  8.  
  9. Disconnect the 7P connector from the recirculation motor. Remove the self-tapping screws and the recirculation motor from the heater unit.
  10.  

To install:

  1. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make sure the motor runs smoothly.
  2.  

Specific to:

Honda Accord 2007-2008

  1. Open the glove box. Remove the damper from the glove box, and then let the glove box hang down.
  2.  
  3. Disconnect the wiring harness from the recirculation motor. Remove the self-tapping screws and the recirculation motor from the heater unit.
  4.  

To install:

  1. Install the motor in the reverse order of removal. After installation, make sure the motor runs smoothly.
  2.  

 
label.common.footer.alt.autozoneLogo