Honda Civic/CRX/del Sol 1984-1995 Repair Guide

Cooling Fan

Print

TESTING



  1. Turn the ignition switch ON .
  2.  
  3. Check for ground at the thermo-switch, when the engine reaches the proper operating temperature the switch should close and complete the ground.
  4.  
  5. Check the wiring, the relays, the control unit, if these are within specification, replace the thermo-switch.
  6.  
  7. Turn the ignition switch OFF .
  8.  
  9. Disconnect the cooling fan wire connector.
  10.  
  11. Connect 12 volts to terminal A of the cooling fan wire connector terminal and ground terminal B .
  12.  
  13. The cooling fan should run smoothly, if not as specified replace the cooling fan
  14.  

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable.
  2.  
  3. Drain the cooling system and remove the upper hose, if required.
  4.  
  5. Disconnect the fan motor wire connector.
  6.  
  7. Remove the fan shroud attaching bolts.
  8.  
  9. Remove the fan and shroud as an assembly.
  10.  
  11. Remove the fan and motor from the shroud.
  12.  

To install:
  1. Install the fan in position on the radiator and tighten the mounting bolts to 7 ft. lbs. (10 Nm).
  2.  
  3. Connect the electrical lead. Connect the upper hose and fill the cooling system, if required.
  4.  

 
label.common.footer.alt.autozoneLogo