REMOVAL & INSTALLATION
See Figure 1
- Remove control knob handle.
- Remove door corner finisher panel.
- Remove mirror body attaching screws, and then remove mirror body
- For 1994-91 models, install the mirror assembly and tighten the screws. For 1992-95 models, the nuts. Tightening nuts for 1992-95 models to 3.6 ft. lbs. (5 Nm.).
- Replace the cover panel.
Apply sealer to the rear surface of door corner finisher panel during installation to prevent water leak. Check for water leaks with a source of low pressure water after installation is complete.