Honda Civic/CRX/del Sol 1984-1995 Repair Guide

Windshield Glass

Print

REMOVAL & INSTALLATION



See Figures 1 through 6

The removal and installation of the windshield must be done carefully, improper installation can cause the windshield to crack or shatter. An assistant must be used to insure that the windshield is positioned properly in the opening.



Click image to see an enlarged view

Fig. Fig. 1: Common Window glass and retaining components-sedan



Click image to see an enlarged view

Fig. Fig. 2: Common window glass and retaining components-hatchback



Click image to see an enlarged view

Fig. Fig. 3: Carefully remove the windshield using a wire cutting tool

  1. Remove the inside rearview mirror.
  2.  
  3. Remove the cowl cover and the windshield moldings. The moldings can be removed by pulling them upward.
  4.  
  5. Cut the urethane bonding from around the windshield using a sharp knife. Separate the windshield from the vehicle.
  6.  

To install:
  1. Clean the windshield area so it is free of old urethane bonding that may be loose. Clean the support spacers and reposition them on the studs.
  2.  
  3. With the aid of a helper, place the replacement windshield in the opening and position it in the center of the opening. Mark the glass at the supports, once it is centered, using a grease pencil or masking tape. This will help position it properly.
  4.  



Click image to see an enlarged view

Fig. Fig. 4: Positioning the windshield glass properly during installation by making alignment marks with tape

  1. Remove the windshield from the opening and place it on a suitable support, clean the inside of the glass. Apply clear glass primer in a 1 inch path around the perimeter of the windshield and wipe with a clean cloth.
  2.  
  3. Apply a 15mm path of blackout primer around the top and sides of the windshield. Apply a 1 inch path to the bottom of the windshield. Allow three minutes drying time.
  4.  
  5. Position the windshield bonding compression spacers around the opening for the windshield.
  6.  



Click image to see an enlarged view

Fig. Fig. 5: Proper installation of the windshield



Click image to see an enlarged view

Fig. Fig. 6: Apply the window sealer in the proper thickness in the locations shown

  1. Apply a 12mm bead of urethane around the inside of the opening.
  2.  
  3. With the aid of a helper, install the windshield glass in position, aligning the reference marks made earlier. Push the windshield into position until it bottoms on the spacers and the top molding is flush with the roof line.
  4.  
  5. Clean excess urethane from the glass using a suitable solvent. Install the moldings.
  6.  
  7. Use pieces of masking tape around the windshield to hold the molding until the urethane cures.
  8.  
  9. Install the cowl cover and the inside mirror.
  10.  
  11. When the urethane cures, remove the tape and water test the windshield for leaks.
  12.  

 
label.common.footer.alt.autozoneLogo