Honda Civic/CRX/del Sol 1984-1995 Repair Guide

Back-Up Light Switch

Print

REMOVAL & INSTALLATION



The back-up light switch is located on the transaxle (side nearest firewall) next to the clutch cable mount bracket. The switch has two wires coming from it that run through a plastic cover.

  1. Disconnect the electrical lead from the back-up light switch.
  2.  
  3. Using an open end type wrench, remove the switch from the transaxle, note that some fluid will drain from the transaxle and should be replaced.
  4.  
  5. Install the new switch in place and torque it to 18 ft. lbs. (25 Nm).
  6.  
  7. Connect the wires and check the operation of the switch.
  8.  

 
label.common.footer.alt.autozoneLogo