Honda Civic/Del Sol 1996-2000

Lower Ball Joint

Print

INSPECTION





Click image to see an enlarged view

Fig. View of the lower ball joint and castle nut

  1. Raise and safely support the vehicle.
  2.  
  3. Place a suitable jack under the lower control arm and lift the arm upward 2 inches (50mm).
  4.  
  5. Carefully grasp the upper and lower portion of the front tires and attempt to rock back and forth.
  6.  
  7. If looseness is felt at the lower portion of the tire proceed as follows:
    1. Using a suitable prytool pry between the steering knuckle and the lower control arm.
    2.  
    3. If looseness is present replace the lower joint.
    4.  

  8.  

REMOVAL & INSTALLATION



This procedure is performed after the removal of the steering knuckle and requires the use of special press tools. In addition a large sturdy vise is needed. After replacement of the ball joint, the ball joint retaining clip is installed onto the boot using a Clip Guide Tool or their equivalent.

  1. Remove the brake caliper, and brake rotor from the steering knuckle assembly.
  2.  
  3. Remove the steering knuckle assembly from the vehicle.
  4.  
  5. Pry off the ball joint boot snap-ring and remove the boot.
  6.  
  7. Check the boot condition and replace if damaged or deteriorated.
  8.  
  9. Install the ball joint removal/installer around the ball joint spindle with the large end facing out. Install and tighten the ball joint castle nut to hold the tool in position.
  10.  
  11. Position the knuckle with the installed tool into a suitable vise, with the ball joint removal base Tool installed over the ball joint base.
  12.  
  13. Tighten the vise to press the ball joint out of the steering knuckle.
  14.  

To install:

  1. Position the new ball joint into the hole of the steering knuckle.
  2.  
  3. Install the ball joint removal/installer on the ball joint spindle side of the steering knuckle the small end facing out.
  4.  
  5. Position the installation base on the ball joint base and set the assembly in a large vise. Tighten the vise to press the ball joint into the steering knuckle.
  6.  
  7. Pack the interior of the ball joint boot with grease.
  8.  
  9. Adjust the boot clip guide tool with its adjusting bolt until the end of the tool aligns with the groove on the boot. Slide the clip over the installed onto the boot using the clip guide tool and into position on the ball joint boot and seat the ball joint boot snap-ring in the groove of the ball joint.
  10.  

 
label.common.footer.alt.autozoneLogo