Honda_Cr-V_2001-2006

Brake Pads

Print

Removal & Installation



2001 Models

CAUTION
Dust and dirt accumulating on brake parts during normal use may contain asbestos fibers from production or aftermarket brake linings. Breathing excessive concentrations of asbestos fibers can cause serious bodily harm. Exercise care when servicing brake parts. Do not sand or grind brake lining unless equipment used is designed to contain the dust residue. Do not clean brake parts with compressed air or by dry brushing. Cleaning should be done by dampening the brake components with a fine mist of water, then wiping the brake components clean with a dampened cloth. Dispose of cloth and all residue containing asbestos fibers in an impermeable container with the appropriate label. Follow practices prescribed by the Occupational Safety and Health Administration (OSHA) and the Environmental Protection Agency (EPA) for the handling, processing, and disposing of dust or debris that may contain asbestos fibers.

  1. Raise and safely support the vehicle. Remove the rear wheels.
  2.  
  3. Remove the brake caliper mounting bolts and remove the caliper without disconnecting the brake fluid line. Support the caliper so it does not hang on the brake line.
  4.  
  5. Remove the brake pads and retaining clips from the caliper.
  6.  
  7. If equipped with caliper-activated parking brakes; use tool J-37617 or equivalent, to rotate the piston clockwise until it retracts into the bore. Align the notches of the piston face so the centerline of the notches is perpendicular to the centerline of the mounting bosses.
  8.  

To install:

  1. Install the new brake pads and clips in the caliper and install the caliper in the mounting bracket.
  2.  
  3. Tighten the caliper mounting bolts to 12-17 ft. lbs. (16-24 Nm), or 32 ft. lbs. (43 Nm) on vehicles with shoe-type parking brakes.
  4.  
  5. Install the rear wheels. Check the brake fluid level.
  6.  
  7. Pump the brake pedal until pressure is felt before moving the vehicle.
  8.  

2002-06 Models

CAUTION
Dust and dirt accumulating on brake parts during normal use may contain asbestos fibers from production or aftermarket brake linings. Breathing excessive concentrations of asbestos fibers can cause serious bodily harm. Exercise care when servicing brake parts. Do not sand or grind brake lining unless equipment used is designed to contain the dust residue. Do not clean brake parts with compressed air or by dry brushing. Cleaning should be done by dampening the brake components with a fine mist of water, then wiping the brake components clean with a dampened cloth. Dispose of cloth and all residue containing asbestos fibers in an impermeable container with the appropriate label. Follow practices prescribed by the Occupational Safety and Health Administration (OSHA) and the Environmental Protection Agency (EPA) for the handling, processing, and disposing of dust or debris that may contain asbestos fibers.

  1. Remove the caliper pin bolts.
  2.  
  3. Lift off the caliper and suspend it safely.
  4.  
  5. Remove the pads and shims.
  6.  
  7. Remove the pad retainers.
  8.  
  9. Installation is the reverse of removal. Coat both sides of the shims and the backs of the pads with brake grease. Torque the bolts to 16 ft. lbs. (22 Nm).
  10.  

 
label.common.footer.alt.autozoneLogo