Honda_Cr-V_2001-2006

Starter

Print

Removal & Installation



2.0L Engine
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove or disconnect the following:

    Negative battery cable
     
    Starter wiring harness connectors
     
    Starter motor
     

  4.  

To install:

  1. Install or connect the following:

    Starter motor. Tighten the bolts to 33 ft. lbs. (44 Nm).
     
    Starter wiring harness connectors. Tighten the battery cable nut to 79 inch lbs. (9 Nm).
     
    Negative battery cable
     

  2.  

2.4L Engine
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove or disconnect the following:

    Negative battery cable
     
    Knock sensor connector
     
    Starter wiring harness connectors
     
    Starter motor

    Click image to see an enlarged view

    Fig. Starter mounting

     

  4.  

To install:

  1. Install or connect the following:

    Starter motor. Tighten the upper bolt to 33 ft. lbs. (44 Nm); the lower bolt to 47 ft. lbs. (64 Nm).
     
    Starter wiring harness connectors. Tighten the battery cable nut to 84 inch lbs. (9 Nm).
     
    Knock sensor connector
     
    Negative battery cable
     

  2.  

 
label.common.footer.alt.autozoneLogo