Honda_Cr-V_2001-2006

Transfer Case Unit

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Drain the transaxle fluid.
  4.  
  5. Remove or disconnect the following:

    Negative battery cable
     
    Heated Oxygen Sensor (HO 2 S) connector on 2001 models
     
    Exhaust front pipe on 2001 models
     
    Rear driveshaft
     
    Transfer assembly and bracket
     

  6.  

To install:

  1. Install the transfer assembly and bracket with a new O-ring seal. Tighten the 10mm bolts to 33 ft. lbs. (44 Nm) and the 8mm bolts to 17 ft. lbs. (24 Nm).
  2.  
  3. Install or connect the following:

    Rear driveshaft. Tighten the bolts to 24 ft. lbs. (32 Nm).
     
    Exhaust front pipe
     
    HO 2 S connector
     
    Negative battery cable
     

  4.  
  5. Fill the transaxle to the correct level and check for leaks.
  6.  

 
label.common.footer.alt.autozoneLogo