Removal & Installation
- Before servicing the vehicle, refer to the Precautions Section. Also see the IMA system disabling before proceeding with any procedure.
Remove or disconnect the following:
Negative battery cable
- Lubricate the crankshaft seal lip with grease prior to installation.
- Install the front crankshaft seal using Special Tools 07749-0010000 and 07746-0010400 until it bottoms against the oil pump housing.
Install or connect the following:
Crankshaft pulley. Tighten the bolt to 14 ft. lbs. (20 Nm), plus an additional 90 degrees.
- Start the engine and check for leaks.