Honda_Odyssey_2001-2006

Hydraulic Control Module

Print

Removal & Installation



2001-04 Models
With TCS

WARNING
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water. Be careful not to damage or deform the brake lines during removal and installation. To prevent the brake fluid from flowing, plug and cover the hose ends and joints with a shop towel or equivalent material.

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the intake air duct.
  4.  
  5. Push the modulator unit connector lock (A), and turn the connector lever (B).
  6.  
  7. Disconnect the modulator unit connector (C).
  8.  
  9. Disconnect the brake lines, then remove the modulator unit (D).

    Click image to see an enlarged view

    Fig. View of the modulator connector lock (A), connector lever (B), connector (C) and modulator unit (D)-2001-04 models with TCS

  10.  

To install:

  1. Install the modulator unit, then connect the brake lines. Tighten the flare nuts to 11 ft. lbs. (15 Nm).
  2.  
  3. Bleed the brake system, starting with the front wheels.
  4.  
  5. Reinstall the intake air duct.
  6.  
  7. Start the engine, and check that the ABS indicator and TCS indicator go off.
  8.  
  9. Test-drive the vehicle, and check that the ABS indicator and TCS indicator do not come on.
  10.  

Without TCS

WARNING
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water. Take care not to damage or deform the brake lines during removal and installation. To prevent the brake fluid from flowing, plug and cover the hose ends and joints with a shop towel or equivalent material.

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the intake air duct.
  4.  
  5. Disconnect the modulator unit connector (A) and the pump motor connector (B).
  6.  
  7. Disconnect the brake lines, then remove the modulator unit (C).

    Click image to see an enlarged view

    Fig. View of the modulator connector (A), pump motor connector (B) and modulator unit (C)-2001-04 models without TCS

  8.  

To install:

  1. Install the modulator unit, then connect the brake lines. Tighten the flare nuts to 11 ft. lbs. (15 Nm).
  2.  
  3. Connect the modulator unit connector and the pump motor connector.
  4.  
  5. Bleed the brake system, starting with the front wheels.
  6.  
  7. Reinstall the intake air duct.
  8.  
  9. Start the engine, and check that the ABS indicator goes off.
  10.  
  11. Test-drive the vehicle, and check that the ABS indicator does not come on.
  12.  

 
label.common.footer.alt.autozoneLogo