Honda_Passport_1997-2002

Wheel Bearings

Print

Adjustment



The front wheel bearings are not adjustable.

Removal & Installation



2-Wheel Drive
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Raise and support the front end.
  4.  
  5. Remove the caliper from the anchor plate and suspend it out of the way.
  6.  
  7. Disconnect the ABS sensor.
  8.  
  9. Remove the rotor.
  10.  
  11. Remove the bolts attaching the hub to the knuckle.
  12.  
  13. Installation is the reverse of removal. Torque the hub bolts to 76 ft. lbs. (103 Nm).

    Click image to see an enlarged view

    Fig. Front hub-2WD models

  14.  

4-Wheel Drive
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Place the transfer case in 2WD.
  4.  
  5. Raise and support the front end.
  6.  
  7. Remove the caliper from the anchor plate and suspend it out of the way.
  8.  
  9. Remove the rotor.
  10.  
  11. Loosen the caulking around the front driveshaft nuts. Remove the nuts and discard them.
  12.  
  13. Remove the 4 hub retaining bolts.
    NOTE
    If the hub is difficult to remove, install 2 long bolt in the bolt holes and strike them to loosen the hub.

  14.  
  15. Installation is the reverse of removal. Torque the hub bolts to 76 ft. lbs. (103 Nm). Use new driveshaft nuts, torquing them to 181 ft. lbs. (245 Nm). Apply new caulking. The caulk should be free of cracks when applied.

    Click image to see an enlarged view

    Fig. Front hub-4WD models

  16.  

 
label.common.footer.alt.autozoneLogo