Honda_Passport_1997-2002

Control Panel

Print

Removal & Installation



  1. Disconnect the negative battery cable.
  2.  
  3. Remove instrument panel driver lower cover assembly.
  4.  
  5. Remove meter cluster assembly:
  6.  
  7. Remove glove box.
  8.  
  9. Remove the control lever attaching screws.
  10.  
  11. Pull the control lever assembly out and disconnect the fan switch and air conditioning switch connectors.
  12.  
  13. Remove control level assembly.
  14.  
  15. Disconnect control cables at each unit side.

    Click image to see an enlarged view

    Fig. 1. Control cable 2. Control lever assembly 3. Meter cluster assembly 4. Glove box 5. Instrument panel drive lower cover assembly 6. Fan switch-A/C switch connector

  16.  

To install:

  1. Installation is the reverse of the removal procedure. Adjust the control cables, as outlined in the following steps.

    Click image to see an enlarged view

    Fig. Control cable adjustment

  2.  
  3. To adjust the air source control cable:
  4.  
  5. Slide the control lever to the left ("CIRC" position).
    1. Connect the control cable at the "CIRC" position of the link unit of the blower assembly and secure it with the clip.
    2.  

  6.  
  7. To adjust the temperature control cable:
    1. Turn the control knob to the left ("MAX COLD" position).
    2.  
    3. Connect the control cable at the "COLD" position of the temperature control link of the heater unit and secure it with the clip.
    4.  

  8.  
  9. To adjust the air select control cable:
    1. Turn the control knob to the right ("DEFROST" position).
    2.  
    3. Connect the control cable at the "DEFROST" position of the mode control link of the heater unit and secure it with the clip.
    4.  

  10.  
  11. Check the control cable operation.
  12.  

 
label.common.footer.alt.autozoneLogo