Honda_Passport_1997-2002

Axle Shaft, Bearing & Seal

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove or disconnect the following:

    Rear wheel
     
    Disc brake caliper and bracket
     
    Disc brake rotor
     
    Wheel speed sensor bracket
     
    Parking brake cable and bracket
     
    Parking brake shoes
     
    Axle shaft
     
    Snapring and discard it
     

  4.  
  5. Break the retainer ring with a chisel.
  6.  
  7. Break the bearing cage with a chisel.
  8.  
  9. Press the bearing race off the axle shaft with the bearing holder and oil seal

    Click image to see an enlarged view

    Fig. Rear axle bearing and related parts-w/drum brakes



    Click image to see an enlarged view

    Fig. Rear axle bearing and related parts-w/disc brakes

  10.  

To install:

  1. Install or connect the following:

    New oil seal into the bearing housing
     
    Bearing housing onto the axle shaft
     
    Bearing, press it onto the axle shaft
     
    New snapring
     
    Axle shaft. Use new lockwashers and tighten the bearing holder nuts to 54 ft. lbs. (74 Nm).
     
    Parking brake shoes
     
    Parking brake cable and bracket
     
    Wheel speed sensor bracket
     
    Disc brake rotor
     
    Disc brake caliper and bracket. Tighten the bracket bolts to 76 ft. lbs. (103 Nm).
     
    Rear wheel
     

  2.  
  3. Check the rear axle oil level and adjust as necessary.
  4.  

 
label.common.footer.alt.autozoneLogo