Honda Pilot - 2003-2005

Control Assembly

Print

Removal & Installation



  1. Disconnect the negative battery cable.
  2.  
  3. Remove the console rear trim, as follows:
    1. Starting at the top, gently pull out the console rear trim (A) to detach the clips (B), then pull out the trim to detach the remaining clips (C), and disconnect the rear heater-A/C passenger's control panel-unit connectors (D) and accessory power socket connector (E). If equipped with rear entertainment system, disconnect the rear entertainment system jack connector (F).

      Click image to see an enlarged view

      Fig. Starting at the top, gently pull out the console rear trim (A) to detach the clips (B), then pull out the trim to detach the remaining clips (C), and disconnect the rear heater-A/C passenger's control panel-unit connectors (D) and accessory power socket connector (E). If equipped with rear entertainment system, disconnect the rear entertainment system jack connector (F)

    2.  

  4.  
  5. Remove the self-tapping screws and the rear heater-A/C control switch (A) from the console rear trim (B).

    Click image to see an enlarged view

    Fig. Remove the self-tapping screws and the rear heater-A/C control switch (A) from the console rear trim (B)

  6.  
  7. Install the control switch in the reverse order of removal. After installation, operate the control switch controls to see whether it works properly.
  8.  
  9. Install the rear console trim in the reverse of the removal procedure.
  10.  

 
label.common.footer.alt.autozoneLogo