Honda Pilot - 2003-2005

Stabilizer Links

Print

Removal & Installation



  1. Raise and safely support the front of the vehicle
  2.  
  3. Remove the front wheels.
  4.  
  5. Remove the flange nuts (A) while holding the respective joint pins (B) with a hex wrench (C), and remove the stabilizer link (D).

    Click image to see an enlarged view

    Fig. Remove the flange nuts (A) while holding the respective joint pins (B) with a hex wrench (C), and remove the stabilizer link (D)

  6.  

To install:

  1. Install the stabilizer link (A) on the stabilizer bar (B) and damper (C) with the joint pins (D) set at the center of each moving range.

    Click image to see an enlarged view

    Fig. Install the stabilizer link (A) on the stabilizer bar (B) and damper (C) with the joint pins (D) set at the center of each moving range

  2.  
  3. Install the flange nuts, and lightly tighten them.
  4.  
  5. Place a jack under the lower arm, and raise the suspension to load it with the vehicle's weight.
  6.  
  7. Tighten the flange nuts (A) to the torque specifications shown in the accompanying illustration, while holding the respective joint pins (B) with a hex wrench (C).

    Click image to see an enlarged view

    Fig. Tighten the flange nuts (A) to the torque specifications shown here, while holding the respective joint pins (B) with a hex wrench (C)

  8.  

 
label.common.footer.alt.autozoneLogo