Honda Pilot - 2003-2005

Power Windows

Print

Window Switch Control Panel



Removal & Installation
Power Window Master Switch

NOTE
This procedure is for door lock switch removal and installation and requires the use of Trim pad remover, Snap-on A177A or equivalent, commercially available trim panel removal tool.

  1. Remove the mirror mount cover. Take care not to scratch the door panel, as follows:
    1. Lower the door glass fully.
    2.  
    3. Carefully detach the clips and release the hook (A), then pry out the mirror mount cover (B) by hand in the sequence shown.
    4.  
    5. Disconnect the door tweeter connector (C).

      Click image to see an enlarged view

      Fig. Carefully detach the clips and release the hook (A), then pry out the mirror mount cover (B) by hand in the sequence shown. Disconnect the door tweeter connector (C)

    6.  

  2.  
  3. Remove the inner handle (A), as follows. Take care not to scratch the door panel.
    1. Pry out the cap (B), and remove the screw (C).
    2.  
    3. Pull the inner handle forward and out half-way.
    4.  
    5. Disconnect the inner handle rod (D) and power door lock switch connector (E). For some models on driver's side, disconnect the driving position memory switch connector (F).

      Click image to see an enlarged view

      Fig. View of the inner handle (A), cap (B), screw (C), inner handle rod (D), power door lock switch connector (E) and driving position memory switch connector (F)

    6.  

  4.  
  5. Detach the clips and hooks, then remove the speaker grille. Remove the screws.
  6.  
  7. Detach the clips (A) and release the hooks (B), then remove the switch panel (C). Take care not to scratch the door panel. Disconnect the power window switch (door multi-plex control unit) connectors (D).
  8.  
  9. On driver's side, disconnect the power mirror switch connector (E). Pry out the cap (F), and remove the screw (G).

    Click image to see an enlarged view

    Fig. Detach the clips (A) and release the hooks (B), then remove the switch panel (C). Take care not to scratch the door panel. Disconnect the power window switch (door multi-plex control unit) connectors (D). On driver's side, disconnect the power mirror switch connector (E). Pry out the cap (F), and remove the screw (G)

  10.  
  11. Remove the four mounting screws, then remove the master switch (A) from the panel (B).

    Click image to see an enlarged view

    Fig. Remove the four mounting screws, then remove the master switch (A) from the panel (B)

  12.  
  13. Installation is the reverse of the removal procedure.
  14.  

 
label.common.footer.alt.autozoneLogo