Honda Pilot - 2003-2005

Coil Spring

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Support the vehicle under the lower control arm.
  4.  
  5. Remove or disconnect the following:

    Rear wheel
     
    Stabilizer link from the lower arm
     
    Wheel speed sensor wiring harness from the lower arm. Do not disconnect the connector.
     
    Upper shock absorber flange bolt
     
    Lower control arm bolts
     

  6.  
  7. Lower the floor jack and remove the coil spring and spring seats.
  8.  

To install:


NOTE
Use new self-locking nuts for assembly.

  1. Place the coil spring and spring seats on the lower control arm and raise into position. Tighten the inboard bolt to 61 ft. lbs. and the outer bolt to 54 ft. lbs. (74 Nm).
  2.  
  3. Install or connect the following:

    Rear wheel

    Click image to see an enlarged view

    Fig. Exploded view of the rear spring assembly

     

  4.  

 
label.common.footer.alt.autozoneLogo