Honda Prelude Accord Civic S2000 2001-2006

Brake Shoes

Print

Removal & Installation



Accord And Civic
  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following: Rear wheels and brake drumsUpper return spring from the brake shoes

    Rear wheels and brake drums
     
    Upper return spring from the brake shoes
     

  4.  
  5. Push the retainer springs and turn the tension pins to release the shoes from the backing plate. Lower the brake shoe assembly and remove the lower return springBrake shoe assembly from the backing plateParking brake cable from the brake shoe leverUpper return spring, self-adjuster lever, and self-adjuster spring. Separate the brake shoes.Wave washer, parking brake lever, and pivot pin from the brake shoe by removing the U-clip.

    Lower the brake shoe assembly and remove the lower return spring
     
    Brake shoe assembly from the backing plate
     
    Parking brake cable from the brake shoe lever
     
    Upper return spring, self-adjuster lever, and self-adjuster spring. Separate the brake shoes.
     
    Wave washer, parking brake lever, and pivot pin from the brake shoe by removing the U-clip.
     

  6.  

To install:

  1. Install or connect the following: Brake cylinder grease to the sliding surface of the pivot pin and insert the pin into the brake shoe.Parking brake lever and wave washer on the pivot pin and pinch the U-clip with a pair of pliers to secure the pivot pin to the shoeParking brake cable to the parking brake leverAdjuster spring to the adjuster lever first, then to the brake shoeAdjuster bolt/clevis assembly and the upper return springBrake shoes to the backing plateLower return spring, the tension pins and retaining springsConnect the upper return spring

    Brake cylinder grease to the sliding surface of the pivot pin and insert the pin into the brake shoe.
     
    Parking brake lever and wave washer on the pivot pin and pinch the U-clip with a pair of pliers to secure the pivot pin to the shoe
     
    Parking brake cable to the parking brake lever
     
    Adjuster spring to the adjuster lever first, then to the brake shoe
     
    Adjuster bolt/clevis assembly and the upper return spring
     
    Brake shoes to the backing plate
     
    Lower return spring, the tension pins and retaining springs
     
    Connect the upper return spring
     

  2.  
  3. Turn the adjuster bolt to force the brake shoes out until the brake drum will not easily go on. Back off the adjuster bolt just enough that the brake drum will go on and turn easily.
  4.  
  5. Install the wheels.
  6.  
  7. Depress the brake pedal several times to set the self-adjusting brake. Adjust the parking brake.
  8.  

 
label.common.footer.alt.autozoneLogo