Honda_Ridgeline_2006

Front Crankshaft Seal

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove or disconnect the following:

    Negative battery cable
     
    Accessory drive belts
     
    Side engine mount
     
    Valve cover
     
    Crankshaft pulley
     
    Front cover
     
    Timing belt
     
    Top Dead Center (TDC) sensor, if equipped
     
    Crankshaft timing sprocket
     
    Front crankshaft seal
     

  4.  

To install:

  1. Lubricate the crankshaft seal lip with grease prior to installation.
  2.  
  3. Install the front crankshaft seal so that it is flush with the surface of the oil pump housing.
  4.  
  5. Install or connect the following:

    Crankshaft timing sprocket
     
    Top Dead Center (TDC) sensor, if equipped
     
    Timing belt
     
    Front cover
     
    Crankshaft pulley. Tighten the bolt to 181 ft. lbs. (245 Nm).
     
    Valve cover
     
    Side engine mount
     
    Accessory drive belts
     
    Negative battery cable
     

  6.  
  7. Check the engine oil level and add if necessary.
  8.  
  9. Start the engine and check for leaks.

    Click image to see an enlarged view

    Fig. Front crankshaft seal installation

  10.  

 
label.common.footer.alt.autozoneLogo