Honda_Ridgeline_2006

Control Cables

Print

Adjustment



  1. From under the hood, open the cable clamp (A), then disconnect the heater valve cable (B) from the heater valve arm (C).

    Click image to see an enlarged view

    Fig. From under the hood, open the cable clamp (A), then disconnect the heater valve cable (B) from the heater valve arm (C)

  2.  
  3. From under the dash, disconnect the heater valve cable housing from the cable clamp (A), and disconnect the heater valve cable (B) from the air mix control linkage (C).
  4.  
  5. Set the temperature control dial to Max Cool (Lo) with the ignition switch ON (II).
  6.  
  7. Attach the heater valve cable (B) to the air mix control linkage (C) as shown step 2. Hold the end of the heater valve cable housing against the stop (D), then snap the heater valve cable housing into the cable clamp (A).
    NOTE
    Make sure the ring-end of the cable is pushed all the way to the base of the pin on air mix control linkage.



    Click image to see an enlarged view

    Fig. View of the cable clamp (A), heater valve cable (B), air mix control linkage (C) and stop (D)

  8.  
  9. From under the hood, turn the heater valve arm (C) to the fully closed position as shown, and hold it. Attach the heater valve cable (B) to the heater valve arm, and gently pull on the heater valve cable housing to take up any slack, then install the heater valve cable housing into the cable clamp (A).

    Click image to see an enlarged view

    Fig. From under the hood, turn the heater valve arm (C) to the fully closed position as shown, and hold it. Attach the heater valve cable (B) to the heater valve arm, and gently pull on the heater valve cable housing to take up any slack, then install the heater valve cable housing into the cable clamp (A)

  10.  

 
label.common.footer.alt.autozoneLogo