Honda_Ridgeline_2006

Upper Control Arm

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Support the control arm at the knuckle.
  4.  
  5. Remove or disconnect the following:

    Wheel
     
    Upper ball joint from the knuckle
     
    Upper arm bolt and the arm
     

  6.  
  7. Installation is the reverse of removal. Install all fasteners loosely and torque them with the weight of the car on the suspension. Use new bolt and nut, and cotter pin. Tighten the arm bolt to 69 ft. lbs. (94 Nm) and the ball joint nut to 36-43 ft. lbs. (49-59 Nm).
  8.  

 
label.common.footer.alt.autozoneLogo