- Disconnect the negative cable from the battery.
- Remove the dash pad.
- Disconnect the connectors from the blower relay the blower motor, the blower resistor (or power transistor) and the fresh and recirculation actuator.
Remove the self-tapping screws (A), the mounting nut (B), the mounting bolt (C) and the blower unit (D).
- Disconnect the 7P connector (A) from the inlet actuator (C).
Remove the self-tapping screws (B) and the inlet actuator (C) from the blower unit (D).
Install in the reverse order of removal.
NOTEAfter installation, make sure the inlet actuator (C) runs smoothly.
NOTEMake sure that there is no air leaking out of the blower and duct joints