Hyundai Car 1999-05

2.0L L4 VIN F Auto 3

Print

Trouble Code: P0457



EVAP System Leak (Fuel Tank Cap) Detected

Possible Causes:



Canister vent (CV) solenoid may be stuck in open position
 
EVAP canister tube, EVAP canister purge outlet tube or EVAP return tube disconnected or cracked, or canister is damaged
 
Fuel filler cap missing, loose (not tightened) or the wrong part
 
Fuel tank pressure (FTP) sensor has failed (mechanical fault)
 
Fuel tank control valve is contaminated, damaged or has failed
 

Trouble Code: P0500



VSS Signal (ABS/TCS Rough Road Signal) Fault

Possible Causes:



VSS signal circuit is open, shorted to ground or system power
 
VSS (Hall) power circuit is open (check Fuse 5 in fuse panel)
 
VSS (Hall) ground circuit is open
 
VSS (Hall) is damaged or has failed
 
PCM has failed
 

Trouble Code: P0501



Vehicle Speed Sensor Circuit Performance

Possible Causes:



VSS signal circuit from the sensor to the I/P Cluster to the PCM is open, shorted to ground or to system power
 
VSS (Magnetic) signal (+) or (-) circuit is open or shorted
 
VSS (Magnetic) is damaged or has failed
 
PCM has failed
 

Trouble Code: P0506



Idle Speed Lower Than Expected

Possible Causes:



ISC motor "open" circuit is open or shorted to ground
 
ISC motor "close" circuit is open or shorted to ground
 
ISC motor is damaged or has failed
 
PCM is damaged
 

Trouble Code: P0507



Idle Speed Higher Than Expected

Possible Causes:



ISC motor control circuit(s) open or shorted to ground
 
ISC motor is damaged or has failed
 
PCM is damaged
 

Trouble Code: P0560



Battery Backup Circuit Malfunction

Possible Causes:



Battery backup circuit is open (check the fuse to the battery)
 
Battery terminals are corroded, dirty or loose
 
Battery has been removed or the cables were disconnected
 
PCM has failed
 
TSB 00-36-013 (12/00) contains information about this code
 

Trouble Code: P0562



System Voltage Low Input

Possible Causes:



Ignition system voltage circuit is open
 
Generator is damaged or has failed (generator output too low)
 
PCM has failed
 

Trouble Code: P0563



System Voltage High Input

Possible Causes:



Generator is damaged or has failed (generator output to high)
 
PCM has failed
 

Trouble Code: P0601



PCM (Internal Controller) Checksum Error

Possible Causes:



Clear the trouble codes and retest for this trouble code. If the same trouble code resets, the PCM has failed and must be replaced to repair this problem.
 

Trouble Code: P0605



PCM (Internal Controller) ROM Error

Possible Causes:



Clear the trouble codes and retest for this trouble code. If the same trouble code resets, the PCM has failed and must be replaced to repair this problem.
 

Trouble Code: P0700



Transmission Control System Signal

Possible Causes:



Clear the trouble codes and retest for this trouble code. If the same trouble code resets, the TCM may have failed.
 

Trouble Code: P0703



Stop Lamp Switch Circuit Malfunction

Possible Causes:



Brake switch signal circuit is open or shorted to ground
 
Brake switch power circuit is open (check power from the relay)
 
Brake switch is damaged or has failed
 
TCM has failed
 

Trouble Code: P0705



Inhibitor (Park/Neutral) Switch Circuit Malfunction

Possible Causes:



P/N switch signal circuit is open or shorted to ground
 
P/N switch power circuit is open (check the power source)
 
P/N switch is out-of-adjustment, damaged or has failed
 
TCM has failed
 
TSB 01-40-020 (7/01) contains information about this code
 

Trouble Code: P0707



Transmission Range Switch Circuit Malfunction (Open)

Possible Causes:



TR sensor signal circuit is open between the switch and PCM
 
TR sensor is damaged or has failed
 
TCM has failed
 
TSB 01-40-020 (7/01) contains information about this code
 

Trouble Code: P0708



Transmission Range Switch Circuit Malfunction (Shorted)

Possible Causes:



TR sensor signal circuit is shorted to ground
 
TR sensor is damaged or has failed
 
TCM has failed
 
TSB 01-40-020 (7/01) contains information about this code
 

Trouble Code: P0712



Transmission Fluid Temperature Sensor Circuit High Input

Possible Causes:



TFT sensor signal circuit is open between sensor and PCM
 
TFT sensor ground circuit is open between sensor and PCM
 
TFT sensor is damaged or has failed
 
PCM has failed
 
TSB 00-40-10 (8/00) contains information about this code
 

Trouble Code: P0713



Transmission Fluid Temperature Sensor Circuit Low Input

Possible Causes:



TFT sensor signal circuit is shorted to ground
 
TFT sensor is damaged or has failed
 
PCM has failed
 
TSB 00-40-10 (8/00) contains information about this code
 

Trouble Code: P0715



Transmission Input Speed Shaft Sensor

Possible Causes:



Input speed sensor signal circuit is open or shorted to ground
 
Input speed sensor is damaged or has failed
 
TCM has failed
 
TSB 1-40-005 (3/01) contains information about this code
 

Trouble Code: P0717



A/T Pulse Generator 'A' Sensor Circuit Malfunction

Possible Causes:



A/T pulse generator 'A' (+) circuit is open or shorted to ground
 
A/T pulse generator 'A' (-) circuit is open or shorted to ground
 
A/T pulse generator 'B' is damaged or has failed
 
TCM has failed
 
TSB 01-40-006-1 (12/01) contains information about this code
 

Trouble Code: P0720



Transmission Output Speed Shaft Sensor

Possible Causes:



Output speed sensor signal circuit is open or shorted to ground
 
Output speed sensor is damaged or has failed
 
TCM has failed
 
TSB 1-40-005 (3/01) contains information about this code
 

Trouble Code: P0722



A/T Pulse Generator 'B' Sensor Circuit Malfunction

Possible Causes:



Pulse generator 'B' (+) or (-) circuit is open or shorted to ground
 
Pulse generator 'B' is damaged or has failed
 
TCM has failed
 
TSB 01-40-006-1 (12/01) contains information about this code
 

Trouble Code: P0731



A/T Incorrect 1st Gear Ratio

Possible Causes:



Solenoid or related pressure switch is damaged or has failed
 
Problems related to the Input Speed or Output Speed sensor
 
Low/Reverse clutch is damaged, leaking or has failed
 
Problems related to the transmission valve body
 

Trouble Code: P0732



A/T Incorrect 2nd Gear Ratio

Possible Causes:



Solenoid or related pressure switch is damaged or has failed
 
Problems related to the Input Speed or Output Speed sensor
 
Low/Reverse clutch is damaged, leaking or has failed
 
Problems related to the transmission valve body
 

Trouble Code: P0733



A/T Incorrect 3rd Gear Ratio

Possible Causes:



Solenoid or related pressure switch is damaged or has failed
 
Problems related to the Input Speed or Output Speed sensor
 
Low/Reverse clutch is damaged, leaking or has failed
 
Problems related to the transmission valve body
 

Trouble Code: P0734



A/T Incorrect 4th Gear Ratio

Possible Causes:



Solenoid or related pressure switch is damaged or has failed
 
Low/Reverse clutch is damaged, leaking or has failed
 
Problems related to the Input Speed or Output Speed sensor
 
Problems related to the transmission valve body
 

Trouble Code: P0735



A/T Incorrect 5th Gear Ratio

Possible Causes:



5th Gear or pressure switch is damaged or has failed
 
Low/Reverse clutch is damaged, leaking or has failed
 
Problems related to the Input Speed or Output Speed sensor
 
Problems related to the transmission valve body
 

Trouble Code: P0736



A/T Incorrect Reverse Gear Ratio

Possible Causes:



Reverse Gear is damaged or has failed
 
Low/Reverse clutch is damaged, leaking or has failed
 
Problems related to the Input Speed or Output Speed sensor
 
Problems related to the transmission valve body
 

Trouble Code: P0712



A/T Damper Clutch Control System Range/Performance

Possible Causes:



Damper Clutch solenoid is sticking or not operating properly
 
Damper Clutch solenoid valve is damaged or has failed
 
TSB 00-40-009 (8/00) contains information about this code
 

Trouble Code: P0742



A/T Damper Clutch Control System Circuit Malfunction

Possible Causes:



Damper Clutch solenoid control circuit is open
 
Damper Clutch solenoid valve is damaged or has failed
 
TSB 00-40-009 (8/00) contains information about this code
 

Trouble Code: P0743



A/T Damper Clutch Control System Circuit Malfunction

Possible Causes:



Damper Clutch solenoid control circuit is shorted to ground
 
Damper Clutch solenoid valve is damaged or has failed
 
TSB 00-40-009 (8/00) contains information about this code
 

Trouble Code: P0745



A/T Pressure Control Solenoid Circuit Malfunction

Possible Causes:



PCS (solenoid) control circuit is open
 
PCS (solenoid) is damaged or has failed
 
TCM is damaged or has failed
 
TSB 00-40-009 (8/00) contains information about this code
 

Trouble Code: P0747



A/T Pressure Control Solenoid Circuit Malfunction

Possible Causes:



PCS (solenoid) control circuit is open
 
PCS (solenoid) is damaged or has failed
 
TCM is damaged or has failed
 
TSB 00-40-009 (8/00) contains information about this code
 

Trouble Code: P0748



A/T Pressure Control Solenoid Circuit Malfunction

Possible Causes:



PCS (solenoid) control circuit is shorted to ground
 
PCS (solenoid) is damaged or has failed
 
TCM is damaged or has failed
 
TSB 00-40-009 (8/00) contains information about this code
 

Trouble Code: P0752



A/T Shift Solenoid 'A' Circuit Malfunction

Possible Causes:



SSA (solenoid) control circuit is open
 
SSA (solenoid) is damaged or has failed
 
TCM is damaged or has failed
 
TSB 00-40-009 (8/00) contains information about this code
 

Trouble Code: P0753



A/T Shift Solenoid 'A' Circuit Malfunction

Possible Causes:



SSA (solenoid) control circuit is shorted to ground
 
SSA (solenoid) is damaged or has failed
 
TCM is damaged or has failed
 
TSB 00-40-009 (8/00) contains information about this code
 

Trouble Code: P0757



A/T Shift Solenoid 'B' Circuit Malfunction

Possible Causes:



SSA (solenoid) control circuit is open
 
SSB (solenoid) is damaged or has failed
 
TCM is damaged or has failed
 
TSB 00-40-009 (8/00) contains information about this code
 

Trouble Code: P0758



A/T Shift Solenoid 'B' Circuit Malfunction

Possible Causes:



SSB (solenoid) control circuit is shorted to ground
 
SSB (solenoid) is damaged or has failed
 
TCM is damaged or has failed
 
TSB 00-40-009 (8/00) contains information about this code
 

Trouble Code: P0765



A/T Pressure Control Solenoid Circuit Malfunction

Possible Causes:



PCS (solenoid) control circuit is shorted to ground
 
PCS (solenoid) is damaged or has failed
 
TCM is damaged or has failed
 
TSB 00-40-009 (8/00) contains information about this code
 

Trouble Code: P0740



Torque Converter Clutch Solenoid Circuit Malfunction

Possible Causes:



Transmission fluid is contaminated, or the fluid level is too low
 
Worn pump bushing and/or the TCC is damaged or has failed
 
Valve body lockup accumulator diameter is out of specification
 
TSB 00-40-009 (8/00) contains information about this code
 

Trouble Code: P0750



Low/Reverse Solenoid Circuit Malfunction

Possible Causes:



L/R solenoid control circuit is open, shorted to ground or power
 
L/R pressure switch is open, shorted to ground or it has failed
 
L/R solenoid is damaged or has failed
 
TCM power ground circuit is open, or the TCM has failed
 
TSB 00-40-009 (8/00) contains information about this code
 

 
label.common.footer.alt.autozoneLogo