Hyundai Car 1999-05

2.5L V6 VIN V Std 4

Print

Trouble Code: P01529



Customer Snapshot Request Error

Possible Causes:



Transmission control module error
 
Check for trouble codes in the transmission control module
 
TSB 1-40-005 (3/01) contains information about this code
 

Trouble Code: P01553



Idle Speed Control Actuator Closing Coil Circuit Open

Possible Causes:



Idle speed actuator closing coil circuit is open or shorted to ground
 
Idle speed actuator is damaged or has failed
 
PCM has failed
 

Trouble Code: P01602



Serial Communication Problem With The TCM

Possible Causes:



CAN network circuit open or shorted to ground
 
CAN network circuit shorted to VREF or system power (B+)
 
TCM has failed
 

Trouble Code: P01605



Rough Road Sensor Circuit Malfunction

Possible Causes:



Acceleration sensor circuit is open or shorted to ground
 
Acceleration sensor is damaged or has failed
 
PCM has failed
 

Trouble Code: P01616



Main Relay Circuit Malfunction

Possible Causes:



Main relay power fuse is open
 
Main relay control circuit to PCM is open or grounded
 
Main relay is damaged or has failed
 
PCM has failed
 

Trouble Code: P01623



Diagnostic Lamp (MIL) Power Stage Malfunction

Possible Causes:



MIL control circuit is open or shorted to ground
 
MIL control circuit is shorted to system power (B+)
 
MIL lamp is missing or has failed
 
PCM has failed
 

Trouble Code: P01624



Cooling Fan Relay Low Circuit

Possible Causes:



Cooling Fan Relay control circuit open or shorted to ground
 
Cooling Fan Relay power circuit from Main Relay is open
 
Cooling Fan Relay is damaged or has failed
 
PCM has failed
 
TSB 00-36-013 (9/00) contains information about this code
 

Trouble Code: P01625



Cooling Fan Relay High Circuit Malfunction

Possible Causes:



Cooling Fan Relay control circuit shorted to system power (B+)
 
Cooling Fan Relay is damaged or has failed
 
PCM has failed
 

Trouble Code: P0153



HO2S-21 (Bank 2 Sensor 1) Slow Response

Possible Causes:



HO2S signal circuit is open or shorted to ground
 
HO2S element is contaminated or it has failed
 
HO2S heater is damaged or has failed
 
Intake air leaks, exhaust manifold leaks or PCV system leaks
 
MAF sensor out of calibration (it may be dirty or contaminated)
 

Trouble Code: P0154



HO2S-21 (Bank 2 Sensor 1) No Activity Detected

Possible Causes:



HO2S signal circuit is open or shorted to ground
 
HO2S element is contaminated or it has failed
 
HO2S heater is damaged or has failed
 
PCM has failed
 

Trouble Code: P0171



Fuel System Too Lean (Bank 1)

Possible Causes:



Air leaks after the MAF sensor, or in the EGR or PCV system
 
Base engine "mechanical" fault affecting one or more cylinders
 
Exhaust leaks located in front of the A/FS or HO2S location
 
Fuel control sensor is out of calibration (i.e., ECT, IAT or MAP)
 
Fuel delivery system supplying too little fuel during cruise or idle periods (e.g., faulty fuel pump or dirty, restricted fuel filter)
 
Fuel injector (one or more) dirty or pressure regulator has failed
 
HO2S is contaminated, deteriorated or it has failed
 
Vehicle driven low on fuel or until it ran out of fuel
 

Trouble Code: P0172



Fuel System Too Rich (Bank 1)

Possible Causes:



Base engine "mechanical" fault affecting one or more cylinders
 
EVAP system component has failed or canister fuel saturated
 
Exhaust leaks located in front of the HO2S location
 
Fuel control sensor is out of calibration (i.e., ECT, IAT or MAF)
 
Fuel delivery system supplying too much fuel during cruise or idle periods (e.g., faulty fuel pump, or faulty pressure regulator)
 
Fuel injector(s) is leaking or stuck partially open (one or more)
 
HO2S is contaminated, deteriorated or it has failed
 

Trouble Code: P0174



Fuel System Too Lean (Bank 2)

Possible Causes:



Air leaks after the MAF sensor, or in the EGR or PCV system
 
Base engine "mechanical" fault affecting one or more cylinders
 
Exhaust leaks located in front of the A/FS or HO2S location
 
Fuel control sensor is out of calibration (i.e., ECT, IAT or MAP)
 
Fuel delivery system supplying too little fuel during cruise or idle periods (e.g., faulty fuel pump or dirty, restricted fuel filter)
 
Fuel injector (one or more) dirty or pressure regulator has failed
 
HO2S is contaminated, deteriorated or it has failed
 
Vehicle driven low on fuel or until it ran out of fuel
 

Trouble Code: P0175



Fuel System Too Rich (Bank 2)

Possible Causes:



Base engine "mechanical" fault affecting one or more cylinders
 
EVAP system component has failed or canister fuel saturated
 
Exhaust leaks located in front of the HO2S location
 
Fuel control sensor is out of calibration (i.e., ECT, IAT or MAF)
 
Fuel delivery system supplying too much fuel during cruise or idle periods (e.g., faulty fuel pump, or faulty pressure regulator)
 
Fuel injector(s) is leaking or stuck partially open (one or more)
 
HO2S is contaminated, deteriorated or it has failed
 

Trouble Code: P0320



Ignition Failure Sensor Circuit Malfunction

Possible Causes:



Ignition failure sensor circuit is open or shorted to ground
 
Ignition failure sensor is damaged or has failed
 
PCM has failed
 

Trouble Code: P0457



EVAP System Leak (Fuel Tank Cap) Detected

Possible Causes:



Canister vent (CV) solenoid may be stuck in open position
 
EVAP canister tube, EVAP canister purge outlet tube or EVAP return tube disconnected or cracked, or canister is damaged
 
Fuel filler cap missing, loose (not tightened) or the wrong part
 
Fuel tank pressure (FTP) sensor has failed (mechanical fault)
 
Fuel tank control valve is contaminated, damaged or has failed
 

 
label.common.footer.alt.autozoneLogo