Hyundai Car 1999-05

Distributor

Print

All engines except the 3.0L and 3.5L (VIN T) V6 are equipped with a Distributorless Ignition System (DIS).

All engines except the 3.0L (VIN T) V6 are equipped with a Distributorless Ignition System (DIS).

Installation



Timing Disturbed
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Set the crankshaft to Top Dead Center (TDC) of the compression stroke for the No. 1 cylinder.
  4.  
  5. Align the timing marks on the distributor gear and the distributor housing.
  6.  
  7. Install the distributor by aligning the groove of the installation flange with the center of the installation stud.
  8.  
  9. Connect the distributor electrical connectors.
  10.  
  11. Install the distributor cap.
  12.  
  13. Check the ignition timing and adjust as necessary.

    Click image to see an enlarged view

    Fig. Aligning the distributor housing and gear mating marks-3.0L Sonata

  14.  

Timing Not Disturbed
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Install the distributor with the rotor-to-housing and the housing-to-engine matchmarks aligned.
  4.  
  5. Install the distributor electrical connectors.
  6.  
  7. Install the distributor cap.
  8.  
  9. Check the ignition timing and adjust as necessary.
  10.  

Removal



  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Remove the distributor cap.
  4.  
  5. Remove the distributor electrical connectors.
  6.  
  7. Matchmark the rotor to the distributor housing.
  8.  
  9. Matchmark the distributor housing to the engine.
  10.  
  11. Unbolt and remove the distributor.
  12.  

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Distributor cap
     
    Distributor electrical connectors
     

  4.  
  5. Matchmark the rotor to the distributor housing.
  6.  
  7. Matchmark the distributor housing to the engine.
  8.  
  9. Unbolt and remove the distributor.
  10.  

Timing Disturbed
  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Set the crankshaft to Top Dead Center (TDC) of the compression stroke for the No. 1 cylinder.
  4.  
  5. Align the timing marks on the distributor gear and the distributor housing.
  6.  
  7. Install or connect the following:

    Distributor, by aligning the groove of the installation flange with the center of the installation stud
     
    Distributor electrical connectors
     
    Distributor cap
     

  8.  
  9. Check the ignition timing and adjust as necessary.
  10.  

Timing Not Disturbed
  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Install or connect the following:

    Distributor, with the rotor-to-housing and the housing-to-engine matchmarks aligned
     
    Distributor electrical connectors
     
    Distributor cap
     

  4.  
  5. Check the ignition timing and adjust as necessary.
  6.  

 
label.common.footer.alt.autozoneLogo