Hyundai Car 1999-05

Multi-Function Switch

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative (-) terminal (A) from the battery.

    Click image to see an enlarged view

    Fig. Battery

  4.  
  5. Take away the bolts (A) shown in the illustration, and then remove the driver airbag module (B).

    Click image to see an enlarged view

    Fig. Air bag module

  6.  
  7. Remove the steering wheel lock nut (A).

    Click image to see an enlarged view

    Fig. Steering wheel lock nut

  8.  
  9. After aligning the marks on the steering shaft and wheel (A), remove the steering wheel using the special tool (09561-11002).
    NOTE
    Do not hammer on the steering wheel to remove it as this may cause damage to the steering column.



    Click image to see an enlarged view

    Fig. Steering wheel removal

  10.  
  11. Remove the steering column upper (A) and lower shrouds (B).

    Click image to see an enlarged view

    Fig. Steering column shrouds

  12.  
  13. Disconnect the two tightening bolt (A) and remove the lower crash pad (B).

    Click image to see an enlarged view

    Fig. Lower crash pad

  14.  
  15. Remove the connectors of the multifunction switch (A).  

    Click image to see an enlarged view

    Fig. Multifunction switch connectors

  16.  
  17. After removing three bolts (A) shown in the following illustration, remove the multifunction switch assembly (B).

    Click image to see an enlarged view

    Fig. Multifunction switch

  18.  
  19. Installation is the reverse of the removal procedure.
  20.  

 
label.common.footer.alt.autozoneLogo