Hyundai Cars 2006-2008

Removal & Installation

Print

Specific to:

Hyundai Entourage 2007-2008

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative (-) battery terminal.
  4.  
  5. Remove the glove box.
  6.  
  7. Disconnect the blend door actuator connector.
  8.  
  9. Loosen the mounting screws and then remove the blend door actuator (A) from the blower unit.
  10.  

To install:

  1. Installation is the reverse of the removal procedure.

    Click image to see an enlarged view

    Fig. Loosen the mounting screws and then remove the blend door actuator (A) from the blower unit

  2.  

Specific to:

Hyundai Accent 2006-2008

Hyundai Azera 2006-2008

Hyundai Elantra 2006-2008

Hyundai Sonata 2006-2008

Hyundai Tiburon 2006-2008

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative cable from the battery.
  4.  
  5. Remove the dash pad.
  6.  
  7. Disconnect the connectors from the blower relay the blower motor, the blower resistor (or power transistor) and the fresh and recirculation actuator.
  8.  
  9. Remove the self-tapping screws (A), the mounting nut (B), the mounting bolt (C) and the blower unit (D).

    Click image to see an enlarged view

    Fig. Blower unit diagram

  10.  
  11. Disconnect the 7P connector (A) from the inlet actuator (C).
  12.  
  13. Remove the self-tapping screws (B) and the inlet actuator (C) from the blower unit (D).

    Click image to see an enlarged view

    Fig. Blend door actuator diagram

  14.  

To install:

  1. Installation is the reverse order of removal.
    NOTE
    After installation, make sure the blend door actuator (C) runs smoothly.


    NOTE
    Make sure that there is no air leaking out of the blower and duct joints.

  2.  

 
label.common.footer.alt.autozoneLogo