Hyundai Cars 2006-2008

Mirrors

Print

Power Mirrors



Diagnosis & Testing

The use of the Hyundai Vehicle Diagnosis will identify the correct procedure for diagnosing the system and where the procedure is located. Inspect for aftermarket devices which could affect the operation of the system. Inspect the easily accessible or visible system components for obvious damage or conditions which could cause the symptom. Faulty electrical connections or wiring may be the cause of intermittent conditions.

If the power mirror system fuse is open and a short to ground in the battery positive voltage circuit is not detected, the fault could be a short to ground in one of the power mirror control circuits. This would open the power mirror system fuse when the mirror switch is pressed.

If both power mirrors are inoperative on one or more axis, the most probable cause is a power mirror switch failure. However, the fault could be an open circuit on two or more of the power mirror control circuits.

The power mirror assembly is equipped with a pigtail harness and is not serviceable. If an internal open or short is detected in the power mirror assembly, replace the power mirror assembly.

The power door mirror switch, a component of CAN, performs CAN communication with the BCM, seat ECU, tilt ECU, passenger side power window switch, and it also performs LIN communication with the switch module and safety ECU.

Check the BCM input/output value of each switch position when you inspect the module to see whether or not it is faulty.

Removal & Installation
Motor

Specific to:

Hyundai Entourage 2007-2008


WARNING
When prying with a flat-tip screwdriver, wrap it with protective tape and also apply protective tape around the related parts in order to prevent damage.

The mirror motor is removed as an assembly.

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the front door quadrant inner cover (A).
    NOTE
    Take care not to damage the fixing clips.



    Click image to see an enlarged view

    Fig. Remove the front door quadrant inner cover (A)

  4.  
  5. Remove the door trim.
  6.  
  7. After disconnecting the connector (A), remove the outside rear view mirror (B).

    Click image to see an enlarged view

    Fig. After disconnecting the connector (A), remove the outside rear view mirror (B)

  8.  

To install:

  1. Installation is the reverse of removal.
  2.  

Specific to:

Hyundai Accent 2006-2008

Hyundai Azera 2006-2008

Hyundai Elantra 2006-2008

Hyundai Sonata 2006-2008

Hyundai Tiburon 2006-2008


WARNING
When prying with a flat-tip screwdriver, wrap it with protective tape and also apply protective tape around the related parts in order to prevent damage.

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the quadrant inner cover (A), then disconnect the connector (B).
  4.  
  5. Remove the tweeter speaker, if equipped.

    Click image to see an enlarged view

    Fig. Quadrant inner cover location

  6.  
  7. After disconnecting the connector (A), remove the outside rear view mirror (B).

    Click image to see an enlarged view

    Fig. Exploded view of outside mirror removal

  8.  
  9. Installation is the reverse of removal.
  10.  

Switch

Specific to:

Hyundai Accent 2006-2008

Hyundai Azera 2006-2008

Hyundai Elantra 2006-2008

Hyundai Entourage 2007-2008

Hyundai Sonata 2006-2008

Hyundai Tiburon 2006-2008

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery terminal.
  4.  
  5. Remove the front door trim panel.
  6.  
  7. Remove the power window switch module.
  8.  
  9. Installation is the reverse of the removal procedure.
  10.  

 
label.common.footer.alt.autozoneLogo