Hyundai Cars 2006-2008

Parking Brake Shoes

Print

Specific to:

Hyundai Accent 2006-2008

Hyundai Azera 2006-2008

Hyundai Elantra 2006-2008

Hyundai Sonata 2006-2008

Hyundai Tiburon 2006-2008

The rear drum brake shoes serve as the parking brakes. Refer to the procedures under Rear Drum Brakes, removal & installation.

Adjustment



Specific to:

Hyundai Entourage 2007-2008

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Raise and safely support the vehicle.
  4.  
  5. Remove the rear wheel and tire.
  6.  
  7. After removing the plug from the disc, rotate the toothed wheel with a screwdriver until the disc does not move, then back it up 5 notches.

    Click image to see an enlarged view

    Fig. After removing the plug from the disc, rotate the toothed wheel with a screwdriver (A) until the disc does not move, then back it up 5 notches

  8.  

Removal & Installation



Specific to:

Hyundai Entourage 2007-2008

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Raise and safely support the vehicle.
  4.  
  5. Remove the rear wheel and tire assembly.
  6.  
  7. Remove the hub cap and rotor.
  8.  
  9. Remove the hub nut (A) and washer (B), then remove the rear hub (C).

    Click image to see an enlarged view

    Fig. Remove the hub nut (A) and washer (B), then remove the rear hub (C)

  10.  
  11. Remove the shoe hold-down pin and spring (A) by pressing then rotating the spring.
  12.  
  13. Remove the adjuster assembly (B) and the lower return spring (C).

    Click image to see an enlarged view

    Fig. Remove the shoe hold-down pin and spring (A) by pressing then rotating the spring. Then, remove the adjuster assembly (B) and lower return spring (C)

  14.  
  15. Remove the strut (B) and the upper return spring (A).

    Click image to see an enlarged view

    Fig. Remove the strut (B) and the upper return spring (A)

  16.  
  17. Remove the retaining ring (B) of the parking brake wire (A) from the back of the backing plate.

    Click image to see an enlarged view

    Fig. Remove the retaining ring (B) of the parking brake wire (A) from the back of the backing plate

  18.  
  19. Disconnect the parking brake wire from the brake shoe.
  20.  

To install:

  1. Install the backing plate.
  2.  
  3. Connect the parking brake wire to the brake shoe.
  4.  
  5. Install the shoe hold-down pin and spring to hold the brake shoe.
  6.  
  7. Install the adjuster assembly and the lower return spring.
  8.  
  9. Install the upper return spring and strut.
  10.  
  11. Lubricate the hub as needed, then install the rear hub.
  12.  
  13. Install the hub nut (A), then lock the nut to the spindle as shown in the accompanying illustration.

    Click image to see an enlarged view

    Fig. After installing the hub nut, lock the nut to the spindle as shown (B)

  14.  
  15. Install the hub cap and the rotor.
  16.  
  17. Install the rear wheel and tire assembly.
  18.  
  19. Tighten the parking brake adjusting nut as needed.
  20.  

 
label.common.footer.alt.autozoneLogo