Hyundai Coupes/Sedans 1986-1993 Repair Guide

Timing Belt Front Cover

Print

See Figures 1, 2 and 3

REMOVAL & INSTALLATION



Except 2972cc Engine
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the engine undercover.
  4.  
  5. Using the proper equipment, slightly raise the engine to take the weight off of the side engine mount. Remove the engine mount bracket.
  6.  
  7. Remove the accessory drive belts, tension pulley brackets, water pump pulley and crankshaft pulley.
  8.  
  9. Remove all attaching screws and remove the upper and lower timing belt covers.
  10.  
  11. Installation is the reverse of the removal procedure. Make sure all pieces of packing are positioned in the inner grooves of the covers when installing.
  12.  



Click image to see an enlarged view

Fig. Fig. 1: Timing belt front cover-1495cc engine



Click image to see an enlarged view

Fig. Fig. 2: Timing belt front cover-1468cc engine



Click image to see an enlarged view

Fig. Fig. 3: Timing belt front cover bolt identification-2972cc engine

2972cc Engine
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the engine undercover.
  4.  
  5. Remove the accessory drive belts.
  6.  
  7. Remove the air conditioner compressor tension pulley assembly.
  8.  
  9. Remove the tension pulley bracket.
  10.  
  11. Using the proper equipment, slightly raise the engine to take the weight off of the side engine mount.
  12.  
  13. Disconnect the power steering pump pressure switch connector. Remove the power steering pump and wire aside.
  14.  
  15. Remove the engine support bracket.
  16.  
  17. Remove the crankshaft pulley.
  18.  
  19. Remove the timing belt cover cap.
  20.  
  21. Remove the timing belt upper and lower covers.
  22.  

To install:
  1. Install the timing covers. Make sure all pieces of packing are positioned in the inner grooves of the covers when installing.
  2.  
  3. Install the crankshaft pulley. Torque the bolt to 108-116 ft. lbs. (150-160 Nm).
  4.  
  5. Install the engine support bracket.
  6.  
  7. Install the power steering pump and reconnect wire harness at the power steering pump pressure switch.
  8.  
  9. Install the engine mounting bracket and remove the engine support fixture.
  10.  
  11. Install the tension pulleys and drive belts.
  12.  
  13. Install the cruise control actuator.
  14.  
  15. Install the engine undercover.
  16.  
  17. Connect the negative battery cable.
  18.  

 
label.common.footer.alt.autozoneLogo