The mirrors are controlled by a single switch assembly, located on the center console. The motors that operate the mirror are part of the mirror assembly and cannot be replaced separately.
The mirror switch consists of a left-right change over select knob and control knobs. The switch is ready to function only when the ignition switch is in the ACC or ON position. Movement of the mirror is accomplished by the motors, located in the mirror housing.
REMOVAL & INSTALLATION
See Figures 1 and 2
- Remove door corner finisher panel.
- Remove mirror body attaching screws, and then remove mirror body.
- Disconnect the electrical lead.
- Installation is in the reverse order of removal.
Apply sealer to the rear surface of door corner finisher panel during installation to prevent water leak.