Hyundai Coupes/Sedans 1986-1993 Repair Guide

Trunk Lid

Print

REMOVAL & INSTALLATION



See Figures 1, 2, 3 and 4

  1. Raise the trunk lid fully.
  2.  



Click image to see an enlarged view

Fig. Fig. 1: Trunk lid components-Excel sedans built before June 1986

  1. Matchmark the lid-to-hinge position.
  2.  



Click image to see an enlarged view

Fig. Fig. 2: Trunk lid components-Excel sedans built from June 1986through 1989

  1. Disconnect the main trunk wiring connectors.
  2.  



Click image to see an enlarged view

Fig. Fig. 3: Trunk lid components-1990-93 Excel, Elantra and Scoupe

  1. Have someone hold the lid while you remove the nuts securing the lid to the hinges.
  2.  



Click image to see an enlarged view

Fig. Fig. 4: Trunk lid components-Sonata

  1. Install the trunk lid in position, aligning the matchmarks made during removal. Install the retaining bolts and tighten to 5-6 ft. lbs. (7-9 Nm). Lubricate the trunk lid latch with white lithium or suitable chassis grease.
  2.  
  3. Adjust the trunk lid as needed.
  4.  

ALIGNMENT



  1. Loosen the trunk lid hinge attaching bolts until they are just loose enough to move the trunk lid.
  2.  
  3. Move the trunk lid for and aft to obtain a flush fit between the trunk lid and the rear fender.
  4.  
  5. To obtain a snug fit between the trunk lid and weatherstrip, loosen the trunk lid lock striker attaching bolts enough to move the lid, working the striker up and down and from side to side as required.
  6.  
  7. After the adjustment is made tighten the striker bolts securely.
  8.  

 
label.common.footer.alt.autozoneLogo