Hyundai Coupes/Sedans 1994-1998 Repair Guide

Pump Motor Relay

Print

TESTING



  1. Remove the relay from its mount near the hydraulic unit.
  2.  
  3. Use an ohmmeter to check continuity. There should be no continuity between terminals 1 and 4. There should be continuity between terminals 2 and 3.
  4.  
  5. Apply 12 volts to terminal 2 and ground terminal 3. With power applied, there should be continuity between terminals 1 and 4.
  6.  
  7. If any test condition is not met, the relay must be replaced.
  8.  

REMOVAL & INSTALLATION



  1. Ensure the ignition key is off.
  2.  
  3. Loosen the screw and remove the ABS relay box cover.
  4.  
  5. Remove the relay from the box by pulling straight up.
  6.  

To Install:
  1. Insert the relay firmly into the relay box.
  2.  
  3. Install the relay box cover and tighten the screw securely.
  4.  
  5. Check system for proper operation.
  6.  

 
label.common.footer.alt.autozoneLogo