Hyundai Santa Fe 2001-05

Rear Main Seal

Print

Removal & Installation



2.7L & 3.5L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Transaxle
     
    Clutch pressure plate and disc, if equipped
     
    Flywheel
     
    Drive plate and adapter plate
     
    Oil seal case bolts and the case
     
    Oil seal
     

  4.  

To install:



Click image to see an enlarged view

Fig. Apply sealant to the areas shown-2.7L and 3.5L engines

  1. Install or connect the following:

    Oil seal. Drive the seal square into the seal case.
     
    Oil seal case so that the oil hole in the separator may be directed downwards. Tighten the bolts to 7-9 ft. lbs. (10-12 Nm).
     
    Drive plate and adapter plate. Tighten the bolt to 53-56 ft. lbs. (73-77 Nm).
     
    Flywheel
     
    Clutch pressure plate and disc, if equipped
     
    Transaxle
     

  2.  
  3. Check the fluid levels.
  4.  
  5. Start the engine and check for leaks.
  6.  


    Click image to see an enlarged view

    Fig. Install the drive plate and adapter plate-2.7L and 3.5L engines


  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Transaxle
     
    Clutch pressure plate and disc, if equipped
     
    Flywheel
     
    Drive plate and adapter plate
     
    Oil seal case bolts and the case
     
    Oil seal
     

  4.  

To install:

Click image to see an enlarged view

Fig. Apply sealant to the areas shown-2.7L and 3.5L engines

  1. Install or connect the following:

    Oil seal. Drive the seal square into the seal case.
     
    Oil seal case so that the oil hole in the separator may be directed downwards. Tighten the bolts to 7-9 ft. lbs. (10-12 Nm).
     
    Drive plate and adapter plate. Tighten the bolt to 53-56 ft. lbs. (73-77 Nm).
     
    Flywheel
     
    Clutch pressure plate and disc, if equipped
     
    Transaxle
     

  2.  
  3. Check the fluid levels.
  4.  
  5. Start the engine and check for leaks.

    Click image to see an enlarged view

    Fig. Install the drive plate and adapter plate-2.7L and 3.5L engines

  6.  

 
label.common.footer.alt.autozoneLogo