Hyundai_Tucson_2005

Blend Door Actuator

Print

Removal & Installation



  1. Disconnect the negative cable from the battery.
  2.  
  3. Remove the dash pad.
  4.  
  5. Disconnect the connectors from the blower relay the blower motor, the blower resistor (or power transistor) and the fresh and recirculation actuator.
  6.  
  7. Remove the self-tapping screws (A), the mounting nut (B), the mounting bolt (C) and the blower unit (D).

    Click image to see an enlarged view

    Fig. Blower motor unit

  8.  
  9. Disconnect the 7P connector (A) from the inlet actuator (C).
  10.  
  11. Remove the self-tapping screws (B) and the inlet actuator (C) from the blower unit (D).

    Click image to see an enlarged view

    Fig. Blend door actuator

  12.  
  13. Install in the reverse order of removal.
    NOTE
    After installation, make sure the inlet actuator (C) runs smoothly.


    NOTE
    Make sure that there is no air leaking out of the blower and duct joints.

  14.  

 
label.common.footer.alt.autozoneLogo