I30 1996-1997




Specific to:

Infiniti I30 1996-1997

Several precautions must be observed with alternator equipped vehicles to avoid damage to the unit.

If the battery is removed for any reason, make sure it is reconnected with the correct polarity. Reversing the battery connections may result in damage to the 1-way rectifiers.
When utilizing a booster battery as a starting aid, always connect the positive to positive terminals and the negative terminal from the booster battery to a good engine ground on the vehicle being started.
Never use a fast charger as a booster to start vehicles.
Disconnect the battery cables when charging the battery with a fast charger.
Never attempt to polarize the alternator.
Do not use test lights of more than 12 volts when checking diode continuity.
Do not short across or ground any of the alternator terminals.
The polarity of the battery, alternator and regulator must be matched and considered before making any electrical connections within the system.
Never separate the alternator on an open circuit. Make sure all connections within the circuit are clean and tight.
Disconnect the battery ground terminal when performing any service on electrical components.
Disconnect the battery if arc welding is to be done on the vehicle.

Removal & Installation

Specific to:

Infiniti I30 1996-1997

  1. Disconnect the negative battery cable.
  3. Loosen the alternator belt and remove from the pulley.
  5. Remove the alternator adjusting bar.
  7. Disconnect the harness connector and cable from the rear of the alternator.
    On some models, the front mounting bolt cannot be removed separately because of insufficient clearance between the alternator and engine coolant inlet tube.

  9. Remove the rear mounting bolt and loosen the front mounting bolt.
  11. Remove the alternator with the front mounting bolt.

To install:

  1. Install the alternator and connect the wiring. Torque the mounting bolts to 15 ft. lbs. (20 Nm).
  3. Install and adjust the alternator belt.
  5. Connect the negative battery cable and check the alternator for proper operation.