ION 2006-2007

Ignition Coil Module

Print

Removal & Installation



2.2L Engine
  1. Turn the ignition OFF .
  2.  
  3. Disconnect the Electronic Ignition (EI) module harness connector.

    Click image to see an enlarged view

    Fig. Remove the EI module attachment screws and the EI module

  4.  
  5. Remove the EI module attachment screws and the EI module.
  6.  

To install:


NOTE
Make sure the interconnect is lined up and the interconnect seal is in place before installing the attachment screws.

  1. Install the EI module and the attachment screws, and tighten the EI module screws to 13 inch lbs. (1.5 Nm).
  2.  
  3. Connect the module harness connector. Push in the connector until a click is heard, then pull back to confirm a positive engagement.
  4.  

 
label.common.footer.alt.autozoneLogo