ION 2006-2007

Ignition Switch

Print

Removal & Installation



  1. Remove the steering column trim covers.
  2.  
  3. Disconnect the ignition switch harness connector.
  4.  
  5. Turn the ignition switch to the run position.
  6.  
  7. Remove the ignition switch screws.
    NOTE
    The ignition switch must be in the run position during removal in order to avoid damage to the ignition switch.

  8.  
  9. Remove the ignition switch from the steering column.
  10.  

To install:

Click image to see an enlarged view

Fig. The removal and installation of the ignition switch

  1. Install the ignition switch and screws on to the steering column, and tighten the screws to 17 inch lbs. (2 Nm).
  2.  
  3. Connect the ignition switch harness connector.
  4.  
  5. Install the steering column trim covers.
    NOTE
    If the ignition switch is replaced and a learn procedure is not performed, the engine will crank but not start or will start and stall immediately.

  6.  
  7. Perform the vehicle theft deterrent system learn procedure.
  8.  

 
label.common.footer.alt.autozoneLogo