ISUZU Amigo/Pick-ups/Rodeo/Trooper 1981-1996

Windshield Wiper Motor and Linkage

Print

REMOVAL & INSTALLATION



See Figures 1, 2, 3, 4 and 5



Click image to see an enlarged view

Fig. Fig. 1: Wiper motor and linkage assembly-Trooper shown (others similar)



Click image to see an enlarged view

Fig. Fig. 2: Disconnecting the wiper motor electrical connectors



Click image to see an enlarged view

Fig. Fig. 3: Removing the wiper motor mounting bolts



Click image to see an enlarged view

Fig. Fig. 4: Gently lift the motor assembly back to gain access to the linkage



Click image to see an enlarged view

Fig. Fig. 5: Disconnecting the linkage from the wiper motor arm

Early Model Pick-Up
  1. Disconnect the negative (-) battery cable.
  2.  
  3. Remove the wiper blade and arm.
  4.  
  5. Remove the seal and nut.
  6.  
  7. Remove the wiper motor assembly by removing retaining bolts and remove the motor link nut.
  8.  
  9. Remove the link assembly.
  10.  

To install:
  1. Install the link assembly.
  2.  
  3. Install the wiper motor assembly and retaining bolts.
  4.  
  5. Install the seal and nut.
  6.  
  7. Install the wiper blade and arm.
  8.  
  9. Connect the negative (-) battery cable and check operation.
  10.  

Late Model Pick-Up, Amigo and Rodeo
  1. Disconnect the negative (-) battery cable and wiper motor connector.
  2.  
  3. Remove the wiper motor bracket screws and pull the motor out of the cowl far enough to disconnect the motor from the linkage at the ball joint.
  4.  
  5. Remove the wiper arm cap, nut and arm.
  6.  
  7. Remove the cowl vent cover and linkage from the access hole.
  8.  

To install:
  1. Install the linkage and cowl vent cover.
  2.  
  3. Install the wiper arm cap, nut and arm.
  4.  
  5. Connect the motor to the linkage at the ball joint, install the motor and retaining screws.
  6.  
  7. Connect the negative (-) battery cable and wiper motor connector.
  8.  

Trooper
  1. Disconnect the negative (-) battery cable.
  2.  
  3. Remove the wiper arm assembly from the linkage.
  4.  
  5. Remove the link pivot nut.
  6.  
  7. Remove the center and left work hole covers.
  8.  
  9. Disconnect the motor wiring.
  10.  
  11. Remove the wiper motor assembly with the link assembly intact.
  12.  

To install:
  1. Install the wiper motor assembly with the link assembly intact.
  2.  
  3. Connect the motor wiring.
  4.  
  5. Install the center and left work hole covers.
  6.  
  7. Install the link pivot nut.
  8.  
  9. Install the wiper arm assembly to the linkage.
  10.  
  11. Connect the negative (-) battery cable and check operation.
  12.  

 
label.common.footer.alt.autozoneLogo