Infiniti Car 1998-05

Control Module

Print

Removal & Installation





Click image to see an enlarged view

Fig. VDC/TCS/ABS control unit location-G35

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the right side instrument panel.
  6.  
  7. Remove the lower instrument panel cover.
  8.  
  9. Disconnect the control unit wiring and harness.
  10.  
  11. Remove the component from its mounting.
  12.  

To install:

  1. Installation is the reverse of the removal procedure.
  2.  



Click image to see an enlarged view

Fig. Control unit location-1998-1999 I30



Click image to see an enlarged view

Fig. Control unit location-2000-2001 I30

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the right side instrument panel.
  6.  
  7. Remove the lower instrument panel cover.
  8.  
  9. Disconnect the control unit wiring and harness.
  10.  
  11. Remove the component from its mounting.
  12.  

To install:

  1. Installation is the reverse of the removal procedure.
  2.  
  3. On 1996-1999 vehicles, be sure that the sensor shield ground cable is secured with the lower mounting bolt.
  4.  



Click image to see an enlarged view

Fig. VDC/TCS/ABS control unit location-M45

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the lower instrument panel.
  6.  
  7. Remove the glove box. Remove the instrument assist panel.
  8.  
  9. Disconnect the control unit wiring and harness.
  10.  
  11. Remove the component from its mounting.
  12.  

To install:

  1. Installation is the reverse of the removal procedure.
  2.  



Click image to see an enlarged view

Fig. VDC/TCS/ABS control unit location-Q45

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the lower instrument panel cover.
  6.  
  7. Remove the instrument panel finisher plate.
  8.  
  9. Remove the glove box assembly. Remove the glove box cover.
  10.  
  11. Remove the instrument panel bracket.
  12.  
  13. Disconnect the ECM wiring connector. Remove the ECM.
  14.  
  15. Disconnect the control unit wiring and harness.
  16.  
  17. Remove the component from its mounting.
  18.  

To install:

  1. Installation is the reverse of the removal procedure.
  2.  

 
label.common.footer.alt.autozoneLogo