Infinity_FX35_FX45_2003-2005

Transfer Case Unit

Print

Removal & Installation





Click image to see an enlarged view

Fig. Transfer case-to-transmission mounting bolt tightening sequence

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Raise and safely support the vehicle.
  4.  
  5. Remove the tunnel stay. Remove fixing bolts and nuts of tunnel stay and member stay, then remove those parts from vehicle.
  6.  
  7. Remove the exhaust front tube.
  8.  
  9. Remove the front and rear driveshafts.
  10.  
  11. Disconnect the transfer assembly wiring harness connector and separate the wiring harness from the transfer assembly.
  12.  
  13. Remove the air breather hose.
  14.  
  15. Support the transfer assembly with a jack.
  16.  
  17. Remove the engine rear mounting.
  18.  
  19. Remove the transfer mounting bolts and separate the transfer from the transmission.
    CAUTION
    Secure the transfer assembly to a jack or similar support.

  20.  

To install:

  1. Install the transfer mounting bolts and mount the transfer onto the transmission. Tighten the bolts to 27 ft. lbs. (37 Nm) in the sequence shown:

    Bolt No. 1 (75mm)
     
    Bolt No. 2 (45mm)
     
    Bolt No. 3 (40mm)
     
    Bolt No. 4 (30mm)
     

  2.  
  3. Install the engine rear mounting.
  4.  
  5. Install the air breather hose.
  6.  
  7. Disconnect the transfer assembly wiring harness connector and separate the wiring harness from the transfer assembly.
  8.  
  9. Install the front and rear driveshafts.
  10.  
  11. Install the exhaust front tube.
  12.  
  13. Install the tunnel stay. Install fixing bolts and nuts of tunnel stay and member stay, then install those parts in the vehicle.
  14.  
  15. Check the fluid level and for fluid leakage.
  16.  

 
label.common.footer.alt.autozoneLogo