Infinity_QX4_1998-2003

Power Windows

Print

Window Motor & Regulator



Removal & Installation

NOTE
Note that the step numbers correspond with the numbers in the door panel illustration.

  1. For the front door, remove the inside handle escutcheon.
  2.  
  3. For the front door, remove the power window switch, then disconnect the connectors.
  4.  
  5. For the front door, remove the door armrest.
  6.  
  7. For the front door, remove the bolts securing the door panel.
  8.  
  9. For the front door, pull on door finisher to remove clips from door panel and remove door finisher, then disconnect glass hatch and fuel lid opener switch connector.
  10.  
  11. For the rear door, remove inside handle escutcheon.
  12.  
  13. For the rear door, remove power window switch, then disconnect the connector.
  14.  
  15. For the rear door, remove door armrest cap.
  16.  
  17. For the rear door, remove bolts securing door panel.
  18.  
  19. For the rear door, pull on door finisher to remove clips from door panel and remove door panel.

    Click image to see an enlarged view

    Fig. Door panel removal and installation-(1 of 2)



    Click image to see an enlarged view

    Fig. Door panel removal and installation-(2 of 2)

  20.  
  21. Temporarily reconnect the power window switch and negative battery cable.
  22.  
  23. Operate the power window main switch to raise/lower the door window until the glass bolts can be seen.
  24.  
  25. Remove the inside seal.
  26.  
  27. Remove the glass bolts.

    Click image to see an enlarged view

    Fig. Remove the glass bolts

  28.  
  29. Raise the front door glass and hold it in place with suitable tool.
  30.  
  31. Disconnect the harness connector from the regulator assembly.
  32.  
  33. Remove the bolts and the regulator assembly.

    Click image to see an enlarged view

    Fig. Window regulator

  34.  
  35. Installation is the reverse of the removal procedure.
  36.  

Window Switch



Removal & Installation
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the power window switch, then disconnect the connectors.
  4.  
  5. Installation is the reverse of the removal procedure.
  6.  

 
label.common.footer.alt.autozoneLogo