Isuzu_Amigo_1998-2000

Starter

Print

Removal & Installation



2.2L Engine
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Remove or disconnect the following:

    Negative battery cable
     
    Starter harness connections
     
    Starter motor

    Click image to see an enlarged view

    Fig. View of the starter location and starter electrical connectors (1, 2)-2.2L engine

     

  4.  

To install:

  1. Install or connect the following:

    Starter motor. Tighten the fasteners to 18 ft. lbs. (25 Nm)
     
    Starter harness connections
     
    Negative battery cable
     

  2.  

3.2L Engine
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Remove or disconnect the following:

    Negative battery cable
     
    Heated Oxygen (HO 2 S) sensor connectors
     
    Exhaust front left pipe
     
    Heat shield
     
    Starter wiring connectors
     
    Starter motor by moving it toward the bottom of the engine

    Click image to see an enlarged view

    Fig. Exploded view of the heat protector (3), electrical connectors (4), mounting bolts (5) and starter assembly (6)-3.2L engine

     

  4.  

To install:

  1. Install or connect the following:

    Starter motor. Tighten the bolts to 30 ft. lbs. (40 Nm).
     
    Starter wiring connectors. Tighten the retainers to 80 inch lbs. (9 Nm).
     
    Heat shield
     
    Exhaust front left pipe. Tighten the stud nuts to 49 ft. lbs. (67 Nm) and the nuts to 32 ft. lbs. (43 Nm).
     
    Heated Oxygen (HO 2 S) sensor connectors
     
    Negative battery cable
     

  2.  

 
label.common.footer.alt.autozoneLogo