Isuzu_Amigo_1998-2000

Removal & Installation

Print

  1. Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
  2.  
  3. Turn the ignition switch to "LOCK".
  4.  
  5. Disconnect the negative battery cable, and wait at least 5 minutes before proceeding.
  6.  
  7. Disconnect the yellow 2-way SRS connector located under the steering column.
  8.  
  9. Loosen the inflator module fixing bolt from behind the steering wheel assembly using a Torx® driver or equivalent until the inflator module can be released from steering assembly.
  10.  
  11. Disconnect the yellow 2-way SRS connector located behind the inflator module.
    WARNING
    The inflator module should always be carried with the trim cover away from your body and should always be laid on a flat surface with the urethane side up. This is necessary because a free space is provided to allow the air cushion to expand in the unlikely event of accidental deployment. Otherwise, personal injury may result

  12.  
  13. Disconnect the horn lead.
  14.  
  15. Remove steering wheel mounting nut.
  16.  
  17. Apply a matchmark (1) across the steering wheel and shaft so parts can be reassembled in their original position, then remove steering wheel.
    WARNING
    Never apply force to the steering wheel in direction of the shaft by using a hammer or other impact tools in an attempt to remove the steering wheel. The steering shaft is designed as an energy absorbing unit.



    Click image to see an enlarged view

    Fig. Before removing the steering wheel, apply a matchmark (1) across the steering wheel and shaft so parts can be reassembled in their original position

  18.  
  19. Move the front wheels to the straight ahead position, then use steering wheel remover J-29752 to remove the steering wheel.

    Click image to see an enlarged view

    Fig. Use a suitable puller to remove the steering wheel



    Click image to see an enlarged view

    Fig. View of the horn lead (1), steering wheel mounting nut (2), inflator module (3) and steering wheel (4)

  20.  

To install:

  1. Install steering wheel by aligning the matchmarks made during removal.
    WARNING
    Never apply force to the steering wheel in direction of the shaft by using a hammer or other impact tools in an attempt to remove the steering wheel. The steering shaft is designed as an energy absorbing unit.

  2.  
  3. Tighten the steering wheel mounting nut to 25 ft. lbs. (34 Nm).
  4.  
  5. Connect the horn lead.
  6.  
  7. Support the module and carefully connect the module connector.
    NOTE
    Pass the lead wire through the tabs on the plastic cover (wire protector) of inflator to prevent lead wire from being pinches.

  8.  
  9. Secure the module with one bolt to relieve weight on the wire connector. Then, tighten the bolts in sequence to 69 inch lbs. (8 Nm).

    Click image to see an enlarged view

    Fig. Air bag module bolt tightening sequence

  10.  
  11. Connect the yellow 2-way SRS connector located under the steering column.
  12.  
  13. Connect the negative battery cable.
  14.  
  15. Turn the ignition switch to ON while watching warning light. Light should flash 7 times and then go off.
  16.  

 
label.common.footer.alt.autozoneLogo