Isuzu Ascender 2003-05

Blend Door Actuator

Print

Removal & Installation



  1. Remove the right rear quarter trim panel.
  2.  
  3. Disconnect the electrical connector from the mode actuator-auxiliary (1).
  4.  
  5. Remove the mode actuator-auxiliary (1) from the HVAC module-auxiliary.
  6.  
  7. Remove the retaining screws from the mode actuator-auxiliary.

    Click image to see an enlarged view

    Fig. Actuator and module assembly

  8.  

To install:

  1. Install the mode actuator (1) to the HVAC module-auxiliary.
  2.  
  3. Install the screws to the mode actuator-auxiliary.
  4.  
  5. Tighten the screws to 17 inch. lbs. (1.9 Nm).
  6.  
  7. Connect the electrical connector to the mode actuator-auxiliary (1).
  8.  
  9. Install the right rear quarter trim panel.
  10.  
  11. Calibrate the HVAC module actuators.
  12.  

 
label.common.footer.alt.autozoneLogo