Isuzu Ascender 2003-05

Brake Caliper

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    /23
     
    Tire and wheel assembly
     
    Caliper fluid line, plug the line and discard the copper washers
     
    Bolts retaining the caliper to the rotor
     
    Caliper from the rotor
     

  4.  

To install:

  1. Clean and lubricate the sleeves and bushings with silicon grease.
  2.  
  3. Install or connect the following:

    Caliper in position over the rotor
     
    Mounting bolts and tighten to 38 ft. lbs. (51 Nm)
     
    Fluid lines to the caliper using new washers and tighten to 33 ft. lbs. (45 Nm)
     
    Wheel and tire assembly
     

  4.  
  5. Refill the master cylinder to the correct level. Bleed the brake system if the fluid lines were disconnected from the caliper.
  6.  

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Remove or disconnect the following:

    2 / 3 of the brake fluid from the master cylinder reservoir
     
    Tire and wheel assembly
     
    Caliper fluid line, plug the line and discard the copper washers
     
    Bolts retaining the caliper to the rotor
     
    Caliper from the rotor
     

  4.  

To install:

  1. Clean and lubricate the sleeves and bushings with silicon grease.
  2.  
  3. Install or connect the following:

    Caliper in position over the rotor
     
    Mounting bolts and tighten to 38 ft. lbs. (51 Nm)
     
    Fluid lines to the caliper using new washers and tighten to 33 ft. lbs. (45 Nm)
     
    Wheel and tire assembly
     

  4.  
  5. Refill the master cylinder to the correct level. Bleed the brake system if the fluid lines were disconnected from the caliper.
  6.  

 
label.common.footer.alt.autozoneLogo