Isuzu Ascender 2003-05

Torsion Bar

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  


NOTE
The following procedure requires the use of the Torsion Bar Unloader tool J-36202.

  1. Remove or disconnect the following:

    Transmission shield, if equipped
     
    Torsion bar unloader tool to relax the tension on the torsion bar adjusting arm screw; record the number of turns necessary to properly install the tool. Remove the adjusting screw and the unloader tool.
     
    Lower link mount nut from one side
     
    Torsion bars by disengaging them
     

  2.  


NOTE
Note the direction of the forward end and side of the torsion bar being removed



Lower link nut from the opposite side
 
Lower link mount, upper link mount nut
 
Upper link mount
 
Torsion bar from the frame
 

To install:

  1. Install or connect the following:

    Torsion bar and support
     
    Upper link mount. Torque the nut to 48 ft. lbs. (68 Nm).
     

  2.  
  3. Place a jack under the torsion bar to release tension.
  4.  
  5. Install or connect the following:

    Lower link mount bushing and nut. Torque the nut to 37 ft. lbs. (50 Nm).
     
    Torsion bar unloader tool. Tighten the tool against the adjusting arm the same number turns recorded earlier and remove the tool. This loads the torsion bars.
     
    Transmission shield, if removed
     

  6.  

  1. Before servicing the vehicle, refer to the precautions section.
    NOTE
    The following procedure requires the use of the Torsion Bar Unloader tool J-36202.

  2.  
  3. Remove or disconnect the following:
    NOTE
    Note the direction of the forward end and side of the torsion bar being removed



    Transmission shield, if equipped
     
    Torsion bar unloader tool to relax the tension on the torsion bar adjusting arm screw; record the number of turns necessary to properly install the tool. Remove the adjusting screw and the unloader tool.
     
    Lower link mount nut from one side
     
    Torsion bars by disengaging them
     



    Lower link nut from the opposite side
     
    Lower link mount, upper link mount nut
     
    Upper link mount
     
    Torsion bar from the frame
     

  4.  

To install:

  1. Install or connect the following:

    Torsion bar and support
     
    Upper link mount. Torque the nut to 48 ft. lbs. (68 Nm).
     

  2.  
  3. Place a jack under the torsion bar to release tension.
  4.  
  5. Install or connect the following:

    Lower link mount bushing and nut. Torque the nut to 37 ft. lbs. (50 Nm).
     
    Torsion bar unloader tool. Tighten the tool against the adjusting arm the same number turns recorded earlier and remove the tool. This loads the torsion bars.
     
    Transmission shield, if removed
     

  6.  

 
label.common.footer.alt.autozoneLogo