Isuzu Ascender 2003-05

Multi-Function Switch

Print

Removal & Installation



  1. Disable the SIR system.
  2.  
  3. Remove the upper and lower trim covers.
  4.  
  5. Tilt the column to the center position.
  6.  
  7. Disconnect the connectors from the turn signal and multifunction switch assembly.
  8.  
  9. Remove 2 pan head tapping screws from the turn signal and multifunction switch assembly.
  10.  
  11. Remove the turn signal and multifunction switch assembly.

    Click image to see an enlarged view

    Fig. Steering column and multi-function switch

  12.  

To install:

  1. Install the turn signal and multifunction switch assembly.
  2.  
  3. Secure by using 2 pan head tapping screws.
  4.  
  5. Tighten the screw on the top of the column to 27 inch. lbs. (3 Nm).
  6.  
  7. Tighten the screw on the side to 62 inch. lbs. (7 Nm).
  8.  
  9. Connect the connectors to the turn signal and multifunction switch assembly.
  10.  
  11. Install the upper and lower trim covers.
  12.  
  13. Enable the SIR system.
  14.  

 
label.common.footer.alt.autozoneLogo